Pulsar PG5250BCO, Руководство оператора

Страница: 10 / 26

ASSEMBLY
10
Attaching Wheels (See fig 1)
• Parts needed - 2 wheels, 2 axles, 2 washers and 2 hair pins.
• Raise or tilt generator so you can slide the wheel axle pin into the wheel, the washer, and the wheel mounting hole
located on the side of the frame.
• Secure the wheel assembly by inserting a hair pin through hole at the end of the wheel axle clevis pin and pressing until
it locks into place.
• Repeat process on the other side of the generator to install the second wheel.
Fig 1
Installing Support Leg (See fig 2)
• Parts needed - Support Leg (2) & M8 screw (2) and 2 nuts.
• Raise the front end of the generator high enough to gain access to the bottom of the frame. Securely position
props underneath to support.
• Line up holes on the support leg bracket to the holes on the front of the generator frame.
• Attach the support leg using M8 screws (2) and nuts.
Fig 2