MAINTENANCE
22
Storage
• Remove any debris that has collected on the generator and around the muffler and controls. Use a vacuum cleaner to
pick up loose debris. If dirt is caked on, use a soft bristle brush.
• Inspect air cooling
cylinder fins and flywheel fan
. Remove any debris if obstructed.
• For short-term storage, start generator once every 7 days.
• For long-term storage, add fuel stabilizer to prevent stale fuel from causing acid and gum deposits in the fuel system
and carburetor.
• Store in
a sheltered location
and use a protective cover to
suitable
from dust.
Draining the fuel tank
•
T
urn the fuel valve to the OFF position.
•
Turn the engine OFF
•
Push the fuel valve knob through the valve holder bracket allowing you to access the petcock.
•
Remove the fuel line that leads
from
the carburetor
to
the petcock by squeezing the ends of the hose clamps and
sliding the fuel line off.
•
If needed, install a fuel hose that will extend to a suitable fuel container large enough to catch the fuel being drained
from the tank.
•
Turn the fuel valve to the ON position and open the fuel tank cap slightly to equalize pressure.
•
When the fuel has drained from the tank, close the fuel valve and reinstall fuel line securely on petcock.
•
Reinstall the fuel valve knob in the valve bracket. Push forward until knob snaps securely into position.
Draining the carburetor
•
Turn the fuel valve to the OFF position.
•
Turn the engine OFF.
•
Position a suitable container under the carburetor drain screw to catch fuel; loosen and remove the screw.
•
Allow fuel to drain completely into container, be sure to wipe up any spilled fuel right away.
•
Retighten drain screw, taking care that the gasket seal is in place.
Consult local hazardous waste management in your area for the proper way to dispose of
used fuel.
CAUTION!
Содержание PG3500MRCO
Страница 1: ...Generator Model PG3500MRCO OPERATOR S MANUAL support pulsar products com...
Страница 24: ...DIAGRAMS 24...
