OPERATION
1
4
Ground Fault Circuit Interrupter
Receptacles are protected by a Ground Fault Circuit Interrupter
(GFCI)
to prevent users from electrocution caused by
moisture or from faulty electrical devices attached to generator.
(GFCI)
receptacles do not protect against short circuits,
overloads, or shocks. To test the
(GFCI)
receptacles depress th eTEST button and make sure the RESET button pops
out. To restore power to the receptacle, depress the RESET button. It is highly recommended that you test the
(GFCI)
receptacles prior to each use.
Moving the Generator
• Disconnect any electronic devices from generator then turn generator off.
• Turn fuel valve to the “OFF” position.
CAUTION!
This product is heavy and requires several people to lift. Lift and lower with your legs by bending
at the knees, not your back, to avoid injury.
Don’t Overload Generator
Make sure you can supply enough rated watts and surge watts for all electronic devices connected to the generator. Rated
watts refer to the power a generator must supply to keep a device running. Surge watts refer to the power a generator
must supply to start an electronic device. This power surge for starting a device usually lasts between 2-3 seconds but this
additional output must be taken into account when selecting the electronic devices you plan to attach to the generator. To
prevent overloading the generator take the following steps:
1. Add up the total rated wattage of all electronic devices that will be connected to the generator simultaneously.
2. Estimate surge watts by adding the item(s) with the highest output (it is unnecessary to calculate the surge output for all
devices as they should be connected one at a time).
3. Add the Surge Watts to the total Rated Watts in step 1. Keep total load within generator’s power capacity.
