Pulsar PG1202S, Руководство оператора, Страница: 12 / 36

PG1202S MANUAL
OPERATION
How to Stop Engine
Receptacles and Extension Cords
Only use high quality, well-insulated, grounded extension cords in good condition with generator receptacles. Follow each
load manufacturer’s power rating recommendation when selecting receptacle and extension cord.
This generator is equipped with the following receptacles:
• Two 120 Volt AC Receptacles.
If reset trips, disconnect all external electrical appliances before pushing the reset button. After reconnecting the external
electrical appliance, if reset continues to trip that indicates that the electrical lead connected to the generator from one or more
of the appliances may have a short circuit. In that event, discontinue use of that item until it has been checked and/or repaired
by a qualified technician.
Never start or stop engine with electrical devices plugged in to the receptacles. Failure to
do so could damage the generator and / or connected electrical devices.
• Always start the engine and let it stabilize before connecting any electronic devices.
• Disconnect all electronic devices before stopping the engine.
Pull cord recoils rapidly and pulls arm towards engine faster than you can let go which
could result in injury.
• To avoid recoil, pull starter cord slowly until resistance is felt, then pull rapidly.
The receptacles are not protected by a GFCI. Use a GFCI protected spider box or GFCI adapter
to connect load to the receptacle.
Turn the engine
ON/OFF switch to the
“OFF” position.
All loads MUST be
disconnected from
the generator. Never
start or stop the
engine with electrical
devices plugged in to
the receptacles
Turn the fuel valve to
the “OFF” position.