Pulsar Imp+i.s., Инструкция по эксплуатации

Страница: 24 / 43

Page
18
Assuming the passcode is the default 1997, then you should enter this.
The ESC key can be used to go back to the previous digit. Finally, when you have
selected all digits pressing the ENTER key again will input the selected pass code
to the
IMP+ i.s.
; if successful the display will show APP (Application). If, however
you input the wrong pass code the
IMP+ i.s.
LCD display will show Fail for 2
seconds and will revert to run mode.
Using The Menu System
The menu system has been designed to make the changing of parameters very
simple. Once in the
Program Mode the display will show a line of text that
displays the menu system. Pressing the Up and Down buttons will scroll the
display between the menu items, (as shown below, starting at APP).
As you press the UP and DOWN buttons to scroll left and right between the
menu options, you can press
ENTER
at any time to select a specific menu
which will then take you to the parameters within the selected menu.
Once you have reached the relevant menu, scroll through the parameters,
and enter the necessary information. To enter the information, use the UP
and DOWN keys to increment or decrement the digit, and the ENTER
key
to shift the flashing digit to the next position, once you have completed
entering the value required pressing the ENTER button again will save the
value.
When you have finished, press
ESC
to go back to the previous level. When
you have reached the top level, then the
IMP+ i.s.
will ask for confirmation
before allowing you to go back into run mode. This is done by pressing
ENTER
at the display prompt.
APP
(Application)
rL
(Relays)
UoL
(Volume)
DiSP
(Display)
Cop
(Compensation)
SyS1
(System)
tESt
( Test)
StA
(Stability)
LOOP ( mA
Output)