Pulsar blackbox 134, Инструкция по эксплуатации

Страница: 59 / 121

Page
51
P135 Stop Bit
This parameter determines the number of Stop Bits to be used, the choices
available are as follows.
1 = 1 Stop Bit (Default) or 2 = 2 Stop Bits.
P136 Data Format
This parameter determines whether a signed or unsigned Data Format is
used.
Select 0 for Unsigned (Default) and 1 for Signed.
P137 Tx Delay
This parameter is used to set a delay, if required, between the
blackbox
switching from the transmit (Tx) mode to the receive mode (Rx).
Default = 5
Remote Alarm
When a Modem is connected to the
blackbox
, via the RS232 port, (Consult
Pulsar or your local distributor for further details), the following parameters
are used to set up the
blackbox
so that when the level reaches a specific alarm
point, as determined by the setting of the relay(s) the unit will dial and connect
to a remote telephone number to provide details of the event.
P985 Tel. No.1
This parameter is used to enter the number of ‘0’s that appear at the beginning
of the telephone number to be dialled that is to receive the message.
Option Description
0= None
No ‘0’s present at the beginning of the
telephone number to be dialled.
1 = Add 0 (Default)
1 ‘0’ present at the beginning of the
telephone number to be dialled.
2= Add 00
2 ‘0’s present at the beginning of the
telephone number to be dialled.