Pulsar blackbox 134, Инструкция по эксплуатации

Страница: 34 / 121

Page
26
LED’s
There are two LED’s which can be seen through the lid, of the
blackbox
enclosure, which will indicate the operational status of the unit while in RUN
mode, as follows:
blackbox
without on board display (standard) .
LED 1
Green LED 2
Red
Run Mode
Off Off No power to unit
Constant
On
Constant
On
Internal Error
Slow
Flashing
Slow
Flashing
Transducer fault
Off Slow
Flashing
Failed Safe /Loss of Echo
Slow
Flashing
Off Healthy signal unit working
normally.
blackbox
with on board display (optional).
LED 1 LED 2 Run Mode
Off Off Relays are in there OFF state.
Constant
On
Off Relay 1 in its ON state
Off Constant
On
Relay 2 in its ON state
Program Mode
This mode is used to set up the
blackbox
or change information already set.
You must use either the PC Software supplied (standard) or alternatively the
unit can be set up with a Hand Held Calibrator (optional), both of which must
be connected to the
blackbox
via the RS 232 Serial Interface.
Those models fitted with the optional display can be set up by using the
integral keypad on the unit.
Entering a value for each of the parameters that are relevant to your
application provides all the programming information.