2
READ AND FOLLOW
SAFETY
INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your system or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury.
warns about hazards that
will
cause death,
serious personal
injury, or major property damage if ignored.
warns about hazards that
can
cause death,
serious personal
injury, or major property damage if ignored.
warns about hazards that
will
or
can
cause
minor personal injury or property damage if ignored.
NOTICE
indicates special instructions not related to
hazards.
Carefully read and follow all safety instructions in this
manual and on equipment.
Keep safety labels in good
condition; replace if missing or damaged.
Incorrectly installed or tested equipment
may fail, causing
severe injury or property damage.
Read and follow instructions in owner's manual when in-
stalling and operating equipment. Have a trained pool
professional perform all pressure tests.
1. Do not connect system to a high pressure or city water
system.
2. Use equipment only in a pool or spa installation.
3. Install pump with at least 2 hydraulically balanced
main drains equipped with correctly installed, screw-
fastened, anti-entrapment certified covers. See Page 4.
4. Trapped air in system can cause explosion. BE SURE
all air is out of system before operating or testing
equipment.
Before pressure testing, make the following safety
checks:
Check all clamps, bolts, lids, and system accessories be-
fore testing.
Release all air in system before testing.
Tighten trap lids to 30 ft. lbs. (4.1 kg-m) torque for testing.
Water pressure for test must be less than 25 PSI
(7.5 kg/cm
2
).
Water Temperature for test must be less than 100
o
F
(38
o
C).
Limit test to 24 hours. After test, visually check system to
be sure it is ready for operation. Remove trap lid and
retighten hand tight only.
NOTICE:
These parameters apply to equipment in this
manual only. For other equipment, consult manufacturer.
NOTICE:
For swimming pool circulation use, pump must
be installed with a hair and lint strainer.
IMPORTANT
SAFETY INSTRUCTIONS
Always follow basic safety precautions with this
equipment, including the following.
To reduce the risk of injury, do not per-
mit children to use this product unless they are closely
supervised at all times.
This pump is for use with permanently
installed pools and may also be used with hot tubs
and spas if so marked. Do not use with storable pools.
A permanently installed pool is constructed in or on
the ground or in a building such that it cannot be
readily disassembled for storage. A storable pool is
constructed so that it may be readily disassembled for
storage and reassembled to its original integrity.
SAVE THESE
INSTRUCTIONS
