pullman Ermator S-Line Series, Руководство по эксплуатации

Страница: 4 / 44

THERMAL PROTECTION
•
The dust extractor is equipped with a safety thermal protector to prevent motor from overheating.
Should thermal protector activate, turn off machine, unplug power cord and check for full dust bag,
vacuum hose clog or filter blockage. It may take up to 45 minutes for the thermal protector to reset.
GROUNDING INSTRUCTION
•
The dust extractor must be grounded. If it should malfunction or breakdown, grounding provides a path
of least resistance for electric current to reduce the risk of electric shock. The dust extractor is equipped
with a cord having an equipment-grounding conductor and grounding plug. The plug must be inserted
into an appropriate outlet that is properly installed and grounded in accordance with all local codes and
ordinances.
SAFETY LABEL
•
The following label appears on the machine, next to the
machines rating plate. Replace label if it is missing,
becomes damaged or illegible. Failure to follow this
warning label may result in fire, electric shock or injury.
1.
UNPACKING
When unpacking the machine, please check that the following accessories are included:
•
The hose with end fittings.
•
Wand.
•
Floor nozzle.
If any of the above-mentioned parts are missing, please contact your local distributor or our sales representative.
For models that do not already have the front casters assembled due to packaging limitations. Assemble the front
casters using the using bolt or nut and washer that are included in the package depending on your application.
Protect the environment:
Please dispose of packaging materials and used machine components in an environmentally safe way according
to local disposal regulations. Always remember to recycle.
1.
FUNCTION
The machine is designed for vacuuming and separating dry, non-combustible dust with an
explosion limit value of

0.1mg/m
3
.
The dust extractor is started by the switch.
Type Models without automatic start Autostart function models
Red switch 2 step 0: Motor off, 1: Motor on N/A
Black switch 3 step N/A 0: Motor off, 1: Motor on, 2: Automatic start
Dust-laden air is then sucked through the inlet valve at high speed via the suction hose. The air is slowed down
by the cyclone and coarse dust particles are separated out, partly by centrifugal force and partly by gravity. Air
and finer particles then pass through the double filter system where separation is made. The machine is designed
for filter cleaning by reverse air pulse.
The separated dust accumulates in the cyclone until the machine is switched off, when it drops through the
bottom flap into the plastic bag. The filter cleaning process is not completed before it is clear that the dust inside
the tank has fallen down into the collection bag. In some extreme cases the adhesive ability of the dust must be
broken manually. This can be done by hitting the dust through the bag or tapping the tank using i.e. a rubber
hammer.
Automatic start function:
When you use the dust extractor together with another machine, there is an
electrical outlet on the dust extractor. Connect the machine to this outlet. Then when you start it up the dust
extractor will also start after 1orms11. 1-2 seconds. When you turn it off, the dust extractor will continue to run
for approximately 10 seconds. To empty the hose. Then stop