Mini SMT Reflow Oven User Manual
Operating Instructions
1. Enter into the setting interface when starts the machine.(temperature zones
from left to right 1/upper 3/upper 5/upper , 2/down 4/down6/down
；
face the
swift of machine
，
(temperature zones from left to right1/upper 3/upper 5/upper ,
2/down 4/down6/down
）
.
2. Rotate Param button slowly to move the white cursor, when button move
counterclockwise,white cursor up. When white cursor refers to the parameters
need changed, slowly rotate value key to change parameter, when rotating
value key clockwise ,the parameter bigger,when rotating value key
counterclockwise, the parameter shrunk. The SPD is belt transmission speed
setting, PRFV is wave number set.
3. After the parameters changed, press the value button for long time, until the
screen reads “successfully”,parameters saved successfully.
4. Press param button long time to enter work interface, the oven start to run
the wave.
5. Press param button long time to return to setting interface to re-set other
waves.
6. After the wave set, only need to change the wave number of PRFV then
select the wave.
7. Six small red switch, control the six tempreture zone lamp.
Attentions:
1. Each temperature wave purposes as follows:
Wave 1 & 2: use the same with soldering the less lead paste, like 85Sn/15Pb
70Sn/30Pb
Wave 3 &4: use the same with soldering the more lead paste, like 63Sn/37Pb
60Sn/40Pb.
Wave 5&6: use the same with soldering high-melting-point Warm prompt: the
machine after shutdown, if you want to restart, the interval of at least 5 s
Wave 7&8: use the same with soldering lead-free solder in melting point, like
Sn/Ag2.5/Cu.8/Sb.5
；
Sn/Bi3.0/Ag3.0
According to the chips size and welding technological requirements, select the