pts Diagnostics CardioCheck PA, Руководство пользователя

Страница: 8 / 25

14 15
Battery Use and Replacement
The CardioChek PA analyzer requires two (2) AAA 1.5 volt high-quality alkaline batteries.
When to Replace the Batteries
The analyzer will give you an indication on the display that the batteries need to be
changed. When the display reads REPLACE BATTERIES, no more tests can be run until the
batteries are changed. Always replace the batteries with high-quality alkaline batteries.
It is recommended to keep a spare set of batteries on hand. To extend battery life, remove
the test strip as soon as a result is displayed. The time/date and results stored in memory
will not be erased when the batteries are changed.
When the REPLACE BATTERIES message is displayed, replace the batteries with
2 new
AAA alkaline batteries of the same brand.
Do not use NiCad or rechargeable batteries.
Caution: Improper installation of batteries can result in decreased battery life or
damage to the analyzer.
Setup
3
How to Install/Replace the Batteries:
1. Open the battery door on the back of the CardioChek PA analyzer by pressing and
sliding it in the direction of the arrow (toward the MEMo Chip port).
2. Remove old batteries from the compartment and properly discard.
3. Insert the new batteries into the battery compartment with the positive (+)
terminals correctly facing as marked on the inside compartment.
4. Replace the battery door. To make sure the batteries were installed correctly,
push either of the two buttons on the front of the analyzer to turn on the
CardioChek PA analyzer.
Warning: Dispose of the old batteries properly.
CardioChek PA Analyzer Menus
The following diagram provides a layout of the menus within the CardioChek PA
analyzer. Detailed information on the use of each menu follows. Use the following
buttons to navigate the menus:
Enter Button
Press this button to turn on the analyzer or to accept the current menu choice.
Next Button
Press this button to turn on the analyzer or to advance to the next menu option.
Note:
Hold and down at the same time for three seconds to turn off the
analyzer.