HDMI Pro Extender (with PoC)
PTN Electronics Limited 2 www.PTN-electronics.com
2. Introduction of Product Appearance
2.1 Product Appearance of TPHD403PLT
Figure 1 Interfaces of TPHD403PLT
No.
Name
Description
①
On
Link
In
Power
On: Used to show the working status, blinks when in normal
working state, turn off when stop working.
Link: Twisted Pair Link status indicator. It will keep on when
connection is successful.
In: When connected with device which supports HDCP and
works normally, this LED will keep on. If the transmitted
signal does not support HDCP, the LED indicator will blink.
Power: Turn red and keep on when power on.
②
ETHERNET
Ethenet port, connect with a router, to work as exchanger along
with the two ETHERNET ports of TPHD403PLR. If they are
connected, the yellow LED indicators on the corresponding
ports will keep on and the green ones will blink when working.
③
HDBT OUT
Connect with the HDBT IN port of TPHD403PLR by using a
single CAT5e cable (90m length in max).
④
HDMI OUT
HDMI IN
HDMI OUT: HDMI output port, connect with an HDMI displayer.
HDMI IN: HDMI input port, connect with an HDMI source
device.
⑤
IR IN&OUT
IN: Connect with IR receiver, receive IR signals and send
them via cable to the other end of the cable, for example the
IR OUT port of TPHD403PLT.
OUT: Connect with IR Emitter, transmit IR signals sent via
cable.
⑥
RS232
Serial port, 3-pin captive screw connector, connect with the
control terminal to control the controlled terminal, supports
bi-directional RS232 control between the transmitter
(TPHD403PLT) and the receiver (TPHD403PLR).
⑦
DC 24V
Connect with a DC 24V power adapter. (Either TPHD403PLT or
TPHD403PLR connecting with power adapter is enough.)
2.2 Product Appearance of TPHD403PLR
