HDMI/IR/RS232 Twisted Pair over Single Cable
PTN Electronics Limited
4
www.PTN-electronics.com
successful.
IN: When connected with devices support HDCP and work normally this LED will
keep on. If devices not support HDCP, the LED will blink.
3)
POWER LED: LED indicator of power. When connect with power, red LED will
keep on.
4)
TP OUT: Single TP cable connects to TP IN port in TPHD402R.
5)
HDMI IN: Connect to HDMI source.
6)
IR IN: Connect with IR receiver, the IR signal received from this port can only send
out in TPHD402R.
NOTICE: When there is IR receiver connected to this port, the port (1) will be
unavailable.
7)
IR OUT: Connect with IR sender, the sending IR signal are received from
TPHD402R.
8)
RS232: RS232 connector.
9)
5V DC: Connect with power supply.
4.1.2. Interface Introduction to TPHD402R
1)
IR: IR receiver.
2)
ON/LINK/OUT LED Indicators: All are green LED.
ON: Working status indicator of this device. When the device works fine, the LED
will keep blinking. And it will get off when the device stops work.
LINK: Twisted Pair Link status indicator. It will keep on when connection is
successful.
OUT: When connected with devices support HDCP and work normally this LED will
keep on. If devices not support HDCP, the LED will blink.
3)
POWER LED: LED indicator of power. When connect with power, red LED will
keep on.
4)
TP IN: Single TP cable connects to TP OUT port in TPHD402T.
5)
HDMI OUT: Connect to HDMI display, HDMI signal output.
