PTN MUH44E KIT, Руководство пользователя

Страница: 12 / 40

MUH44E Kit 4K Home Distribution Hub
PTN Electronics Limited 7 www.PTN-electronics.com
3.3 Connection Procedure
1) Connect HDMI sources (e.g. DVD) to HDMI input ports of the Matrix Switcher via
good quality HDMI cables.
2) Connect the Pre-Installed CAT5e/CAT 6 cable infrastructure to Matrix Switcher
and HDBaseT receivers
（
TPHD-BYE-R
）
via good quality patch leads.
3) Connect HDTV to HDMI output port via HDMI cable.
4) Plug in an HDMI cable in to each of TPHD-BYE-R and connect to the local display
[HDTV].
5) Connect AVR amplifier to SPDIF output port or via the Toslink optic fibre cable.
6) Connect speaker to L&R (RCA) output port via audio cable.
7) Plug the IR Receivers 3.5mm jack into the IR IN sockets on TPHD-BYE-Rs and
plug in the IR Emitters to the IR OUT sockets (1~4) on Matrix Switcher to make up
as IR Matrix.
8) Plug the phoenix connector in to the RS232 socket on the matrix, this will enable
the Matrix Switcher to be controlled via a PC.
9) Plug in a Patch lead from the router in to the Ethernet port on Matrix Switcher to
control Matrix Switcher by TCP/IP protocol.
10) Plug in the Power supply adapter 24V DC and tighten to secure. Once all
components have been connected and the installation is completed, switch on the
mains supply at the socket.
Note:

Connect HDBT ports of Matrix Switcher and far-end TPHD-BYE-R with straight-
through cable.

IR receivers connected to IR IN should be with carrier. If not, send
command %0900. or %0901.to activate native carrier mode or force carrier mode in
the IR matrix launched between Matrix Switcher and far-end TPHD-BYE-R.