HDMI Matrix Switcher 16x16
PTN Electronics Limited
www.PTN-electronics.com
10
All#.
Transfer all input signals to the
corresponding output channels
respectively.
All$.
Switch off all the output channels.
[x1]#.
Transfer signals from the input channel [x1]
to the output channel [x1].
[x1]$.
Switch off the output channel [x1].
[x1] B[x2].
Transfer the signal from the input channel
[x1] to the output channel [x2].
Note:
1) [x1], [x2], [x3] and [x4] are the symbols of input or output channels ranged
according to the model of the matrix switcher. If the symbols exceed the effective
range, it would be taken as a wrong command.
2)
In above commands, “[”and “]” are symbols for easy reading and do not need to be
typed in actual operation.
3)
Please remember to end the commands with the ending symbols “.” and “;”.
4) Type the command carefully, it is case-sensitive.
Detail Examples:
1
、
Transfer signals from an input channel to all output channels: [x1]All.
Example:
“3All.” to transfer signals from the input channel No.3 to all output channels.
2
、
Transfer all input signals to the corresponding output channels respectively:
All#.
Example: If this command is carried out on the matrix, the status of it will be: 1->1,
2->2, 3->3, 4-
>4……16->16.
3
、
Switch off all the output channels: All$.
Example: After running this command, there will be no signals on all the output
channels.
4
、
Check the version of the firmware:
/^Version;
To check the version of the firmware.
5
、
Switch off the detail feedback command from the COM port: /:MessageOff;
I
t will leave the “switch OK” as the feedback, when you switch the matrix.
6
、
Switch on the detail feedback command from the COM port: /:MessageOn;
Switch on the detail feedback information from the COM port. it will show the detail
switch information when send the commands.
7
、
Transfer signals from an input channel to the corresponding output channel:
[x]#.
Example:
“5#.” to transfer signals from the input channel No.5 to the output channel
No.5.
8
、
Switch off an output channel: [x]$.
