PTN IPH300, Руководство пользователя

Страница: 17 / 47

Full HD HDMI over IP Extender
17
In case you want to fix the connection and run the devices all the time when the electric
power is supplied, “Auto” mode is recommended for the devices.
6)
Change operation mode (“Op mode”) to “Auto”, save (“Setting”) and reboot
(“Reboot”) for the devices via Mango.
Once devices are installed and running (green bullet ) as “Auto” mode in the field
network, if an operator wants to change their connection and grouping, the device is to
be disconnected first and changed to “Manual” mode first. You cannot change setting
values for the running device (connection indicated by green bullet ) until it is
disconnected.
7)
Disconnect running devices (green bullet ) via Mango. The bullet turns to grey
( ).
8)
Change “Op mode” to “Manual” from “Auto”, promptly save (“Setting”) and reboot
(“Reboot”).
9)
Change configuration and save (“Setting”).
Note: Please note that you have set devices as “Manual” mode finally.
You will come to know that mode change from “Auto” to “Manual” and vice versa needs
“save” and “reboot” operation in a row.
6.8
Configuration & Operation
6.8.1
Configure One-by-One before Installation
If you want make multiple 1-to-1 connections and/or multiple 1-to-many (1:N) group
connections in a single network through switches, you have to change all devices’ IP
addresses to be unique.
It is recommended that:
- You configure devices one by one as you encoder/decoder’s Ethernet port and
computer’s LAN port via UTP cable. Run Mango on your computer, and;
- Change device’s operation mode to “Manual”, save (“Setting” button), and reboot
(“Reboot” button);
- Install devices to the network.
Be sure that those devices for which you want to build connection are in ‘Manual’
mode. If the device is in ‘Auto’ mode, you have to change it to “Manual” mode, save
(“Setting” button) and reboot (“Reboot” button).