PSV groupe DRC - H22, Руководство пользователя

Страница: 11 / 22

4.2.3 SYSTEM WITH 5 CUTTING ELEMENTS (UNGER).
NOTE : Disconnect the machine from the electricity grid for the
following:
Insert the A-helix (2) inside the body (1) with a slight twisting
motion for a good engagement with the hex output shaft engine.
B-Fit the knife plate (3).
C-Mount the blade (4).
D-Mount plate (5).
E-Fit the knife (6).
F-mount plate (7).
G-Install the ring (8).
4.2.4 PRECAUTIONS FOR INSTALLATION AND MAINTENANCE
SYSTEM UNGER
Make sure that the cutting system is mounted exactly as shown
below. Improper installation, including upside down, causing
breakage of the blades or plates.
The plate must be perfectly knife against the face of the body of
the chopper.
The nut stainless steel machine should not be tightened
significantly.
Change the blades before they are flush with the branches of
the knife.
To surface plates from wear. Plates prevent waste a perfect fit
and cause rapid wear of the blades.
8