ASSEMBLY
To begin assembly of your TEMP2CX you will need a pair of pliers, an adjustable wrench, a Phillips head
screwdriver, a jig saw or snips, a drill with a HSS 1/8” bit and a couple of friends to assist. Lay out all of the
components out to assure you know how parts connect as well as an account for all of the parts.
The Stand Assembly
— Refer to Parts Diagram on page 9
A.
Place two M12 nuts (2) on to the casters (1) pass its post through the bottom of the base (5) and
through the bottom of the vertical support posts (6 & 7). Attach vertical supports (6 & 7) to the base with
a 12mm washer (3), follow with 12mm lock washer (4) and then M12 nut (2) at the lip starting at the
#1 on the base. Continue to attach supports in numerical order as shown in Diagram 1. The longer verti-
cal supports (6) go to the back side of the base. Do not tighten completely, give some tension but give
enough where support can turn, if needed. Continue to do all four and that all “L”-shaped lips are facing
inside, then tighten. See Diagram 1.
B.
After the vertical supports are in place, attach the mid horizontal support braces (8 & 9) using M8 x 20
carriage bolts (18) through followed by 8mm washer (14), follow with 8mm lock washer (17) and then
M8 nut (15). Again, these braces are attached to the vertical supports. Once all the braces are attached,
tighten to vertical supports. The mid horizontal supports are attached to form a 90° angle to the vertical
support. See Diagram 2.
Labeled as #1
Labeled as #4
Labeled as #3
Labeled as #2
NOTE: Match numbered supports
to numbered holes on base/
90°
Diagram #1
Diagram #2
