PSC PowerScan 7000BT SRI, Краткое руководство пользователя

Страница: 13 / 28

Getting Started
Quick Reference Guide
5
Figure 3. Connecting to the Host
Optional Power Connection —
If needed
1
, plug the AC Adapter in
to an approved AC wall socket with the cable facing downwards (as
shown in
Figure 2
) to prevent undue strain on the socket.
Linking the Scanner to a Base Station
To link a scanner to a Base Station, press the Link Button on the Base
Station (see
Figure 4
) for at least one second to place the base in "Link
Mode"then scan the “
Link to a Base Station
” bar code below or the link
bar code located on the Base Station itself using the scanner to be linked.
Allow the system several seconds to create the association between the
two units and exit Link Mode. A successful link is indicated by three
ascending tones from the scanner. A “high-low-high-low” tone indicates
the link attempt was unsuccessful. A single LED flash during this tone
indicates no Base Station was discovered. Two green LED flashes during
this tone indicates that more than one Base Station was discovered and
the scanner did not link.
1. The AC Adapter (Power Cable) is an optional device used only if the host/terminal cannot
by itself supply adequate power to drive the Base Station (via the interface cable).
U S
B
IB
M
K
e
yb
oar
d
W
ed
ge
RS
-2
3
2 or...
or...
or...
Link to a Base Station