PSC PowerScan 7000BT SRI, Краткое руководство пользователя

Страница: 12 / 28

4 PowerScan® 7000BT SRI
Connection
Figure 2
shows how to connect the Base Station to a terminal, PC or
other host device. Turn off the host before connection and consult the
manual for that equipment (if necessary) before proceeding.
Base Station Connection and Routing —
Fully insert the Power
Cable
1
and Interface (I/F) Cable connectors into their respective ports in
the underside of the Base Station (see
Figure 2
). Alternatively, you can
either loop the cables around the routing clips and back through the
routing channel to the front of the Base Station as shown, or the cables
can be fed directly out the back of the Base Station via the routing clips.
Figure 2
. Connecting the Base Station
Host Connection —
The interface type was specified at the time your
scanner was ordered, however you should verify before connection that
the scanner’s cable type is compatible with your host equipment. Most
connections plug directly into the host device as shown in
Figure 3
. Key-
board Wedge interface cables have a ‘Y’ connection where its female end
mates with the male end of the cable from the keyboard and the remain-
ing end at the keyboard port on the terminal/PC.
1. The AC Adapter (Power Cable) is an optional device used only if the host/terminal cannot
by itself supply adequate power to drive the Base Station (via the interface cable).
Bottom of Base Station
Routing
Clips
Base
Station
I/F Cable
Power Cable
Routing
Channel
Power Cable
Optional
AC Adapter
I/F
Cable