PS Engineering
PMA7000BT Series Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-780-0204
Page 2-3
Rev. 1, July 2015
2.4.3
Audio Panel Mounting Rack Installation
Remove the unit from the mounting tray by unscrewing the 3/32" hex-head screw that is in the center of the
unit. Use caution to avoid hitting the photo-detector lens. Carefully slide the unit free of the tray. Set the
unit aside in a safe location until needed. Install the tray using six clip nuts (475-630-0002), and six FHP
6-32 x ½" screws (475-632-0012). The audio selector panel must be supported at front and rear of the
mounting tray.
2.4.4
Audio Panel Tray and Connector Assembly
The unit connectors mate directly with the circuit boards in the PMA7000BT. The connectors are a Molex
crimp-type, and require the use of a Molex hand crimp tool, EDP P/N 11-01-0203, CR6115B (or equiv.).
The connectors are mounted to the unit tray with #4-40 screws (475-440-0007), from the inside of the tray.
Ensure that proper strain relief and chafing precautions are made during wiring and installation, using the
cable clamp (625-001-0002). Secure the ground bar (430-007-0001), if desired using, #6-32 nuts (475-632-
0003) and #6-32 lock nuts (475-632-0004).
Figure 2-2 Audio Panel Tray Assembly Drawing
2.5
Cable Harness Wiring
Referring to the appropriate Appendix, assemble a wiring harness as required for the installation. All wires
must be MIL-SPEC in accordance with current regulations. Two- and three-conductor shielded wire must
be used where indicated, and be MIL-C-27500 or equivalent specification. Proper stripping, shielding and
soldering technique must be used at all times. It is imperative that correct wire be used.
120-430-0420
(70)