[P-4] MultiWave4
MultiWave4 is full combination of P-1 and P-
2. It generates a pseudorandom collection of
frequencies, however instead of generating
sine waves it generates the same waveform
as P-1.
Again, try these settings on your system to
see which one has the highest perceived
benefit in terms of performance.
Servo System
The Power Plant provides a virtual Servo
System to continually correct for any DC off-
set. This will reduce hum from problematic
or sensitive transformers as the Power Plant
produces pure AC waveforms indefinitely
without the need for calibration.
Troubleshooting Guide
The Power Plant P300 sets a new mark for
performance and protection. It has been
designed to bring forth the absolute best
from the connected equipment. In addition
to the audio and video improvements, the
P300 will also provide long-term product
reliability and the piece of mind that
connected equipment is safe from electrical
disturbances.
In the event of abnormal operation with
the P300, please refer to the following
suggestions:
Unit will not turn on
1. Check the obvious. Is it plugged in and
is the AC wall outlet live? This can easily
be tested by using a functional lamp. Plug
the lamp into the wall outlet and see if the
light works. If not, the P300 may be plugged
into a switched outlet, or perhaps the circuit
breaker feeding the outlet has tripped and
needs resetting.
2. After plugging the unit into the wall,
the P300 will only become activated after
flipping the rear switch and pressing the
front panel power button. Be sure that the
unit is both plugged into the wall and turned
on by the both power buttons.
3. Check the Main Fuse. The chances of
the Power Plant’s main fuse being blown
are very remote. However, if the Main
Fuse is blown, the P300 will be completely
inoperable. To check the fuse locate the
section of the back panel labeled "Main
Fuse." It is located between the IEC and the
mail power switch.
Unplug the unit from the wall, remove the
fuse and check its conductivity. If necessary,
replace the fuse and try powering up
the P300. If the main fuse is blown and
a replacement fuse does not solve the
problem, please contact your dealer for
additional service.
The P300 seems to be working, but the
display is blank
The P300 may be in the display blanking
mode. Press the Mode button on the front
panel and the display should turn back on.
6
Содержание Power Plant P300
Страница 1: ......
