Front Panel Controls
There are five buttons on the front panel of the
Power Plant P1000.
1. Power
2. Mode Down
3. Mode Up
4. Edit Down
5. Edit Up
Power On/Off
The power button will activate the front panel dis-
play and output AC power to the Regenerated AC
zones. Power will continue to pass through the
Filtered AC power zone as long as the P1000 is
plugged into a live AC outlet.
Mode
The Mode Up and Mode Down buttons cycle
through the available display modes.
Edit
The Edit Up and Edit Down buttons cycle through
the available options within each display mode.
Display Modes
There are six available display
modes on the front panel of the
P1000. The Mode Up and Mode
Down buttons cycle through the fol-
lowing six modes:
1. Waveform setting
2. Frequency generated
(SINE mode only)
3. Voltage produced
4. Wattage produced
5. Percentage of maximum power output
6. Display blanking mode
Waveform setting
This mode will display the name of the waveform
presently being delivered through the Regenerated
AC outlets. In the SINE mode the P1000 will
generate a perfect SineWave (50-120Hz). Each
of the successive Multiwave modes will gener-
ate a different series of frequencies through the
Regenerated AC outlets.
For more information about each of the
MultiWave™ settings, see the MultiWave II sec-
tion of the manual.
Frequency generated
This mode will display the frequency the P1000 is
generating, while in SINE mode. The frequency
can be adjusted in 1 hertz increments from 50Hz
to 120Hz by using the Edit Up and Edit Down but-
tons. The default setting is 60Hz.
The frequency setting will only be displayed if the
Waveform menu is set to SINE.
Voltage produced
This mode will display the output voltage of the
Power Plant at the Regenerated AC outlets.
Note:
the voltage figure will be flashing.
The output voltage can be adjusted in 1 volt incre-
ments by using the Edit Up and Down buttons.
The range varies depending on the Power Plant
model:
5
