• Up to 1000 watts power delivery - depending on
load requirements.*
• Next generation MultiWave II technology featur-
ing AutoWave and TubeWave.
• Independent power zones keep power for ana-
log, digital and high current equipment electrically
isolated.
• Regenerated AC delivered through 8 Power Port
outlets.
• Filtered AC by High Current Ultimate Outlet™
delivered through 2 Power Port outlets.
• Front panel display for systems monitoring and
user interface.
• Front panel displays waveform setting, output
voltage, wattage and percentage of maximum
power output.
• Massive heat sinkinkg for silent operation
• Reduction of AC line noise by more than 70dB.
• High voltage surge suppression devices for
surge and spike protection.
• Lower AC impedance for better transients.
• Insane toroidal transformer for extended head-
room.
• PS Audio’s brushed aluminum classic chassis.
• PS Bus for communication with other PS Audio
devices.
* Note about power consumption:
The P1000 is capable of delivering up to 1000 watts into
a reactive load and up to 700 watts into a resistive load.
Examples of a reactive load are: most solid state equipment
and video products. An example of a resistive load is: tube
based equipment.
Quick Start Guide
1.
Place the P1000 in a rack or on a shelf in
the audio/video system. If placed on carpet it
is necessary to use isolation or accessory feet
to elevate it above the carpet 1 inch. Failure to
do so could compromise the power regeneration
capabilities of the P1000.
2.
Connect audio/video equipment to the P1000.
There are five electrically isolated duplex recep-
tacles on the P1000, which are oriented verti-
cally.
For optimum performance, we recommend that
equipment with medium wattage power require-
ments be plugged into the “Regenerated AC”
receptacles (2-ch preamps, AV processors, DVD/
CD players, Satellite receivers, PVR’s, D to A con-
verters, low power solid state amplifiers, etc).
Equipment with extremely high wattage power
requirements should be plugged into the “Filtered
AC” receptacles (direct view TVs, plasma or pro-
jection displays, multi-channel, tube or high pow-
ered amplifiers).
3.
Plug the P1000 into a power source such as a
wall outlet. Use the supplied AC power cable, or
an aftermarket power cable. We would strongly
urge the use of an xStream Power Cable.
4.
Turn on the P1000 by pressing the power but-
ton located on the center of the front panel. The
Regenerated AC zone will become active. The
Filtered AC zone immediately becomes active
when the P1000 is plugged into a live outlet.
5.
If desired, select a MultiWave II setting or allow
AutoWave to adapt to the power needs of your
system using the front panel controls.
Default settings
The P1000 comes from the factory with standard
default settings that should work well for most
situations. The type of power delivery can be
configured to achieve the optimal performance
for any system.
3
