Attach Kipping Bar and Linkage Arms
Upper Linkage Arms
1.
Attach either linkage arm by removing the 5/8” x 4” hex head bolt (#5) from the top of the kipping bar.
Place the plastic spacer (#2) on the inside of the linkage arm and place it against the top hole of the
upright.
2.
Attach linkage arm, black plastic spacer, upright and kipping bar using the 5/8” x 4” hex head bolt
(#5), two 5/8” flat washers (#3), and 5/8” lock nut (#4). NOTE: DO NOT over tighten.
3.
Repeat on the opposite side.
5
3
2
3
4
Lower Linkage Arms
1.
Place plastic spacer on the inside of the bottom linkage arms, place it against the 19” hole of the
upright. Attach linkage arm, plastic spacer (#2) and upright using a 5/8” x 3 1/2” bolt (#6), (2) 5/8”
washer (#3) and 5/8” lock nut (#4). DO NOT ATTACH THE SHOCKS. The lower linkage arm should
appear at the same angle as the upper linkage arms.
2.
Repeat on the opposite side, being sure not to over tighten.
6
3
2
3
4
8
(701) 566-0452