Prusa Research Original Prusa SL1, Руководство пользователя

Страница: 36 / 92

3. Covers & Platform
36 Original Prusa SL1 kit assembly
STEP 6 Assembling the sensors
Let's start with the thermistor, take the covercheck top and insert the thermistor
in. The cable channel is only in this top part.
For easier assembly let's assume that the bottom side is marked with the red
colour.
Guide the cable using the channel and make sure it is entirely inside. If not, you
might pinch it after adding the opposite printed part.
About 80 % of the thermistor's tip should be outside the printed part to measure
the temperature properly.
Now, insert the lid safety switch. Insert it from the same side as the thermistor. In
other words, both sensors will have cables on the same side of the printed part.
Also, ensure that the cables are closer to the lower edge of the printed part.
Finish the assembly using the second printed part. This time it is the covercheck
bottom. Ensure no wire is pinched or bent!!!
STEP 7 Assembling the covercheck
Assemble the covercheck onto the left tower sheet. Use the following tips:
The button of the switch has to go through the hole.
The circular hole in the printed parts must fit on the "extension" nut welded to
the sheet.
Secure the covercheck assembly using the M3x5 screw.
Guide the cable down through the hole in the printer. Don't pull the cable, leave it
hanging.
Check the three perforations in the steel sheet we will use them in the next step for
cable management.