Prusa Research i3, Инструкция по сборке

Страница: 3 / 17

Manual for Prusa i3
www.makemendel.com Page 3
Before you Start
Before you start to assemble any of part the XLBot 3D Printer, it is important that you read the build
instructions fully and ensure you understand every part of the instruction.
Go down the BoM (Bill of Material) and tools checklist and ensure that you have all the required parts to
assemble the XLBot 3D Printer. Extra screws have been included into the kit.
If you nd anything missing, please contact us via e-mail at support@makemendel.com
Give yourself large room and clean space during the assembly process. This prevents delicate
components like the electronics or bearings from being damage by dust or blunt force.
To ensure proper alignment of the panel and overall rigidity of the printer, it is highly recommended
that the assembly is done on a -at surface.
Wipe off any excess grease you see on the screws with a napkin or an old towel. Screws are generally
greased in order to prevent rusting during production. Cleaning off excess grease will keep your hands
and printer clean during assembly.
XLBot is a rigid and robust 3D printer once assembled, however during the assembly process, extra care
needs to be taken to make sure delicate parts require more precision than force to come together. If
during the assembly process, you are unsure of the instructions, please contact us for support.
Remember, unless instructed, no part in the assembly process need extra or high amount of force to put
the parts together.
Before starting calibration, ensure that all screws and pulley setscrews are properly tightened.
Common calibrations issues such as skipping and backlash are usually caused by loose pulleys and
unsecured components.