5
P Z 4
In-Ground Pool Installation
INSTALLATION ASSEMBLY USING
P15 STANDARD IN-GROUND KIT
CAUTION: Make sure the voltage is the same as prescribed on the side of the Prozone ozone generator. Overvoltage will void
customer warranty.
Pump
PZ4
Filter
Saddle Clamp
Assembly
¾” Hose
Saddle Clamp
Assembly
Check Valve
¼” Hose
¼” Hose
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Turn pump OFF.
Locate section of existing plumbing in which you choose to install the ENTRANCE leg of the bypass. Location should be in any
accessible area after the pump, but before the filter.
Install Saddle Clamp Top & Bottom, (and adapters if needed), without Bushing, (this will be used as a guide for your installation hole).
Drill a 7/8” hole through one wall of the pipe, using power drill, being careful not to drill too deep to avoid penetrating the opposite side
of the plumbing.
Locate section of existing plumbing in which you choose to install the EXIT leg of the bypass. Location should be in any accessible
area after the filter, and heater (if equipped).
Repeat steps 3 & 4.
Remove both Saddle Clamp Assemblies.
Using components listed, mount one Saddle Clamp Assembly on Entrance bypass location with the INLET side of the Venturi Injector
mounted in the Saddle Clamp Bushing, (ozone ports should be facing upward).
Using components listed, mount the other Saddle Clamp Assembly on Exit bypass location with the ½” x 3” PVC pipe mounted in the
Saddle Clamp Bushing.
Attach one end of ¾” clear hose to Venturi Injector and secure with a metal clamp. Attach other end of ¾”clear hose to ½” x 3” PVC
pipe and secure with a metal clamp.
7/8” Hole Saw
Cut a 6” length of ¼” Polybraid Hose and connect one end to the open ozone port (Marked #1) on the Venturi Injector and the other
end to the OUTLET side of the Check Valve, (Make sure you can blow air through the Check Valve towards the Injector port). Secure
both ends with black plastic clamps.
Connect the remaining section of ¼” Polybraid Hose to the INLET side of the Check Valve and the other end to the barb on top of
the PZ4 Ozone Generator. Secure both ends with black plastic clamps.
Install the PZ4 Ozone Generator on base of pump pack using the metal screws and washers.
Connect the PZ4 Ozone Generator system to the circulation pump or timer. The Prozone system and the circulation pump should
start simultaneously. Use N.E.C. or local code grounding and installation procedures for swimming pool equipment.
Injector
Clamp
Clamp
Air
Flow
Water Flow
Flow
