2
IMPORTANT SAFETY INSTRUCTIONS
Read and Follow All Safety Instructions
WARNING:
Disconnect all power to pool equipment prior to installation, maintenance,
or removal of the PZ4.
WARNING:
Do not permit children to operate this product
WARNING:
To avoid risk of electric shock, fire, or injury, service should only be performed
by a qualified pool service professional.
WARNING:
Installation must be performed in accordance with the National Electric Code
and any applicable local or state installation codes.
WARNING:
When mixing acid with water, ALWAYS ADD ACID TO WATER, NEVER
WATER TO ACID.
SAVE THESE INSTRUCTIONS
P Z 4
•
Read and be familiar with this manual before installing or operating your new PZ4.
•
Voltage must be determined before unit is installed.
•
Replace damaged cord immediately.
•
Do not bury cord.
•
Connect only to a properly grounded, grounding type receptacle.
•
Install at least 5 feet from the inside wall of the pool using non-metallic plumbing. The ozone generator is to be
located one foot above the maximum water level to prevent water from contacting electrical equipment. Install to
provide drainage of compartment for electrical components.
•
Wear safety glasses when drilling and tapping holes for installation of unit.
WARNING
: Short term inhalation of high concentrations of ozone and long term inhalation of low concentrations of ozone
can cause serious harmful physiological effects. Do not inhale ozone gas produced by this device.
NOTE:
The instructions in this document provide general installation guides. Consult your dealer for specific installation instructions.
Additional information is available at www.prozoneint.com. Check system for any visible shipping damage. If damage has occurred,
contact the delivery company and your dealer immediately. Before beginning installation, please turn to the Installation Kit Inventory
Section and verify that all listed parts are on hand.
Tools Needed
: Power Drill with 7/8” hole saw, Screw Driver, Pliers, Knife
