PROZIS Velox, Руководство пользователя

Страница: 8 / 42

EN
8
There are two monitoring modes - speed and cadence.
Switching between modes – Open the battery compartment using a coin and turning it
in the OPEN direction, remove and replace the battery. Turn the battery door in the CLOSE
direction: see page 2, figure A1.
Once the battery is in place, a light will switch on. Red light indicates speed mode, blue
light indicates cadence mode: see page 2, figure A1 and A2.
Speed mode installation - Buckle the curved rubber mat onto the back of the sensor, then
bind the sensor onto the wheel axle using the large rubber band: see page 2, figure B.
Cadence mode installation - Buckle the flat rubber mat onto the back of the sensor, then
bind the sensor onto the pedal crank using the small rubber band: see page 2, figure C.
Download Prozis Go app and register: see page 3, figure D.
a. Turn ON your BT and GPS (Android) or BT (iOS).
b. Click on the + button on the upper right corner of the dashboard (D1), OR, “Add New Device“ on My
Profile section (D2).
c. Select “Sensors” on Prozis Devices list (it may be necessary to select a subcategory first) (D3).
d. Choose “VeloX” on Sensors section (D4).
e. Follow the app’s pairing instructions - “Set Up VeloX” (D5).
f. Define your wheel size (diameter) (D6).
g. Click “Save” to complete the process. Data sync will begin (D7).
For future data synchronization:
Open Prozis GO app > Swipe down > Sync prompt will appear
Note: Do NOT attempt to pair the device through your smartphone’s BT settings. During
the pairing process, Prozis GO app will promptly ask to activate GPS and BT, and to allow
Prozis GO to access smartphone’s GPS. Do NOT attempt to pair the device through your
smartphone’s BT settings.
Troubleshooting
Some issues that arise may be solved by the user. If the problem persists after having tried
the following solutions, please contact Prozis customer service.
PROBLEM CAUSE SOLUTION
Device is not working. Battery has run out. Replace the battery.
The cadence/speed reading is 0 or
there is no cadence/speed reading
while cycling.
Wrong installation. Make sure the position and distance
of the sensor to the magnet are
appropriate.
Unable to pair with the device. Battery has run out. Replace the battery.