Proxxon MICRO-Router MOF, Руководство пользователя

Страница: 9 / 16

use this tool unsafely or incorrectly, you can
suffer serious personal injury.
1. Hold on the power tool by insulated
gripping surfaces when performing an
operations where the cutting tool may
contact hidden wiring or its own cord.
Contact with a "live" wire will make ex-
posed metal parts of the tool "live" and
shock the operator.
2. Always disconnect tool from power
source before making adjustments or
changing bits.
3. Provide clearance under work piece for
router bit when through cutting.
4. Check to see that the cord will not
“hang up” during routing operation.
Lead the cord away from the tool to-
wards the rear.
5. Avoid cutting nails. Inspect for nails
and remove them from the work piece
before operation.
6. Let the motor come to a complete
stop before removing the tool from work
piece and putting the tool down.
7. Do not leave the tool running. Operate
the tool only when hand-held.
8. Check the bit carefully for cracks or
damage before operation. Replace
cracked or damaged bit immediately. Al-
ways handle bits very carefully.
9. Never touch router bits immediately af-
ter use. They may be extremely hot.
Danger of injury!
10. Never tighten collet nut without a bit. It
can be damaged.
11. Always keep hands away from rotating
parts to prevent personal injury.
12. Hold the tool firmly with both hands.
13. Wear hearing protection during ex-
tended period of operation.
14. Draw attention to the need to use cut-
ters of the correct shank diameter and
suitable for the speed of the tool.
15. Some material contains chemicals
which may be toxic. Take caution to
prevent dust inhalation and skin contact.
Follow material supplier safety data.
16. Keep cutting pressure constant. You
could overload the motor.
17. Make sure the bit is not contacting the
work piece before the switch is turned
on.
18. Before using the tool on an actual work
piece, let it run for a while. Watch for
19. vibration or wobbling that could indicate
improperly installed bit.
SAVE THESE INSTRUCTIONS!
WARNING!
Some dust created by power sanding, saw-
ing, grinding, drilling, and other construction
activities contains chemicals known to the
State of California to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement
and other masonry products, and arsenic
and
• chromium from chemically-treated lumber.
Your risk from these exposures varies, de-
pending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are specially
designed to filter out microscopic particles.
9