4
Twist 304 - A430 / BE PTT en / A31008-M2501-E151-1-2M19 / Penguin.fm / 04.11.2014
Te
mpla
te Bali, V
e
rsion
1, 16.0
2
.2012
Setting up the handset for use
The display is protected by a plastic film.
Please remove the protective film!
Inserting the batteries and closing the battery cover
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully charged and discharged.
Warning
Use only the rechargeable
batteries
, i.e. never use conventional (non-rechargeable) batteries as this could result in
significant health risks and personal injury. For example, the batteries could explode. The phone could also malfunc-
tion or be damaged as a result of using batteries that are not of the recommended type.
Please note
◆
The handset is pre-registered with the base station by default. If you have purchased a
model with multiple
handsets
, all handsets will already be registered with the base station. You do not need to register the handset
again.
However, if a handset is not registered with the base station (
Register HS
or
Put into base
is displayed), please
register the handset manually (
¢
page 10).
◆
After the first battery charge
and
discharge, you may place your handset in the charger after every call.
◆
Always repeat the charging and discharging procedure if you remove the batteries from the handset and rein-
sert them.
◆
The batteries may warm up during charging. This is not dangerous.
◆
After a while, the charge capacity of the batteries will decrease for technical reasons.
¤
Insert the batteries
with the polarity in the
correct direction.
The polarity is indicated in
the battery compartment.
¤
Insert the battery cover from
the top.
¤
Then slide the cover upwards
until it clicks into place.
To open the battery cover, for instance to
replace the batteries:
¤
Reach into the notch at the top of the
cover and slide the cover down-
wards.
6 h
¤
Charge the handset in the base station/charging cradle
for
6 hours
.
¤
After charging, remove the handset from the base sta-
tion/charging cradle and only replace it when the batter-
ies are
fully discharged
.
Please note
The handset must only be placed in the designated base
station or charging cradle.