All rights reserved
Page 13
step.5:.Mount.the.unit
The following are the mounting options:
Wall Mount
Ceiling Mount
wall.Mounting
Follow these steps to mount the unit on a wall:
If the unit’s power supply is plugged in, unplug it.
Identify the location at which you intend to mount the unit.Use a Phillips
screwdriver to remove the metal base from the underside of the unit (if
you have not already done so).
Put the mounting plate up to the wall so that the embossed letter “L” is on
top (see figure). If the plate is correctly oriented, the circular tab that is
vertically aligned with the square hole should be on top.
Fasten the mounting plate with two screws through the circular holes of
the plate. Depending on the type of wall you may need to use the two
fasteners provided.
Holding the 5012/5054-SUI so that the connectors on the rear are facing
left, align the two holes on the bottom of the unit with the two tabs on the
mounting plate. Press the unit down so it is flushed with the plate.
Carefully slide the unit to your right until the tabs snap securely onto the
narrow holes of the unit. If the 5012/5054-SUI is mounted correctly no
portion of the mounting plate should protrude from any of the sides of the
unit.
▪
▪
1.
2.
3.
4.
5.
6.
