2.
STARTING PROCEDURE
b)
Through the individuated passages route the connections
cable
inside the trunk or the engine
van leaving the ECU outside
.
(Fig. 2)
Fig. 2
Pag. 4
Central module
+ harness
FRONT BUMPER INSTALLATION
a)
Locate a passage where, from the outside at the
extremity of the bumper,it is possible to take the ECU
harness in the engine compartment driver's side.
REAR BUMPER INSTALLATION
a)
Identify on the car body the zone close to
the extremity of the bumper and, on the side
where it is present the back-gear lamp, a
possible hole of passage toward the interns
of the trunk in order to carry out the
connections cable from the electronic unit.
Central harness
