Proware EP-4604D-G1S3, Руководство пользователя

Страница: 83 / 185

iSCSI GbE to SAS/SATA RAID Subsystem
User Manual 83
TIP: If iSCSI ports are assigned with VLAN ID before creating
aggregation takes place, aggregation will remove VLAN ID. You
need to repeat the steps to set VLAN ID for the aggregation
group.

OP. -> IP settings for iSCSI ports: To change an iSCSI IP
address, click IP settings for iSCSI ports. There are two options:
DHCP or Static. You can select DHCP to acquire and IP address
automatically or Static to set the IP address manually.

OP. -> Become default gateway: The default gateway can be
changed by chicking Become default gateway. There can be only
one default gateway. To remove the default gateway, click OP. of
the LAN that is currently the gateway, and select Remove default
gateway.

OP. -> Enable jumbo frame: The MTU (Maximum Transmission
Unit)) size can be enabled by checking Enable jumbo frame.
Maximum jumbo frame size is 3900 bytes. To disable jumbo frame,
click OP. of the LAN that uses jumbo frame, and select Disable
jumbo frame.
CAUTION: VLAN ID, jumbo frames for both the switching hub
and HBA on host must be enabled. Otherwise, the LAN
connection cannot work properly.

OP. -> Ping host: To verify that the port connection from a target
to the corresponding host data port is good, click Ping host. Enter
the IP address and click Start button. The system sends out six
pings. Or click Stop button to stop the test.