INSTALLATION
ON
Communication Protocol Setup
Select the appropriate Protocol with DIP switch combination.
Switch State
P0
P1
Protocol
(Pin 1)
(Pin 2)
OFF
ON
OFF
ON
OFF
OFF
ON
ON
PELCO-D, 2400 bps
PELCO-D, 9600 bps
PELCO-P, 4800 bps
PELCO-P, 9600 bps
O N
1
2
3
4
If you want to control using DVR or P/T controller, their protocol must
be identical to camera. Otherwise, you can not control the camera.
If you changed camera protocol by changing DIP S/W, the change
will be effective after you reboot the camera.
Factory default of protocol is “Pelco-D, 2400 bps”
Since Pin 3～Pin 4 is only for supplier, DO NOT CHANGE THESE
ORIGINAL STATE. If you change one of these, proper operation can
not be achieved.
Pin 3
PAL / NTSC system selection of Camera. DO NOT
CHANGE THIS PIN.
8
Spee d Dome Camera Instruction Manual
2
ON
O N
1
2
3
4
