11
Spee d Dome Camera Instruction Manual
Check points before operation
Preset and pattern Function Pre-Check
<Go Preset>
<Set Preset>
<Run Pattern>
<Set Pattern>
OPERATION
Before power is applied, please check the cables carefully.
The camera ID of the controller must be identical to that of the target camera. The camera ID can be checked
by reading DIP switch of the camera．
If your controller supports multi-protocols, the protocol must be changed to match to that of the camera.
If you changed camera protocol by changing DIP switch, the change will be effective after you reboot the
camera
Since the operation method can be different for each controller available, refer to the manual for your
controller if camera can not be controlled properly. The operation of this manual is based on the standard
Pelco Controller.
R
Check how to operate preset and pattern function with controller or DVR in advance to operate camera
functlon fulIy when using controller or DVR.
Refer to the following table when using standard Pelco protocol controller.
R
If controller or DVR has no paflern button or function, use shortcut keys with preset nurnbers. For more
information, refer to “Reserved Preset” in this manual
3
Press [Call] input [Preset number]and press [Enter]
Press [Preset] input [Preset number] and press [Enter]
Press [Call] input [Pattern number] and press [Enter]
Please refer to the pattern setup, turn to page 28
