The display mode setting will be remembered even if the power is
turned off. However, this setting will be reset to the factory default
(Regular) if the battery is removed. In addition, this setting will be reset
to the factory default if an adapter not connected to an AC outlet is
plugged into the tuner, even if the battery is installed.
The pitch
is low.
In tune.
The pitch
is high.
The pitch
is low.
In tune.
The pitch
is high.
3: Half-strobe
Tune your instrument until the LEDs stop running and only the center LED is
lit. The LEDs on the right will strobe if the pitch is high, and the LEDs on the
left will strobe if the pitch is low. When the pitch is in tune, only the center
LED is lit.
4: Mirror
Tune your instrument so that the two illuminated LEDs in the left and right
side of the LED meter coincide in the center. The farther your instrument is
from the correct pitch, the farther apart the illuminated LEDs will be.
3. After you’ve chosen the display mode you would like to use, wait
approximately two seconds without pressing any buttons.
The note name display will blink, the display mode will be set, and STV-1JB
will automatically return to tuner mode. With all display modes, the tuning
guide LEDs indicate whether the pitch is high or low.
will light up if the pitch is high, will light up if the pitch is low, and
both will light up when the pitch is in tune.
