■
Choosing a display mode
STV-1JB allows you to choose one of four display mode settings. The
factory setting is Regular mode.
1. Press the CALIB button.
The current calibration setting will blink for several seconds in the note
name display (Light
→
Blink).
2. While the current calibration setting is shown in the note name
display, press the CALIB button again to adjust the setting.
Each time you press the CALIB button you will cycle through the following
settings.
1: Regular
Tune your instrument until the LED at the center of the LED meter is lit. An
LED on the right will light up if the pitch is high, and an LED on the left will
light up if the pitch is low.
The pitch
is low.
In tune.
The pitch
is high.
The pitch
is low.
In tune.
The pitch
is high.
2: Strobe
Tune your instrument until the LEDs stop running. Since the strobe meter
has a higher precision, it allows you to tune with greater accuracy. The
LEDs light up,
running from left to right if the pitch is high and from right to left if the pitch
is low.
