PROUSER 18147, Руководство пользователя, Страница: 7 / 52

7
DISPLAY , FAULT CODE AND TROUBLE SHOOTING
The display shows figure and fault codes as followings:
CODES
TROUBLE SHOOTING
Standby status
Check battery status before charge and during
charge
battery voltage , shows the real-time voltage
of the battery during charging or standby
mode
1. charging current during charge mode
2. working current in 12V DC output mode
1. No connection to battery terminal
2. Short circuit in connection
3. Reverse polarity connection.
Reconnect the clamp to the battery
terminal.
Change the battery
1. The battery’s voltage is too low to accept
charge.
2. Internal open cell
3. Battery with wrong voltage is applied.
Switch off and unplug the charger then
replace the battery
1. Battery’s voltage is too high
2. Battery with wrong voltage is applied
Try again with proper charging voltage
The clamp is loosen during charging
The charger stops output and give a beep
alarm
Check connection and select charging
rage
The battery is fully charged.
The charger keeps a constant voltage to keep
the battery in full charged condition until the
charger is powered off.
In few cases, charge finish very soon but the battery is not able to deliver
expected power. The battery may have lost capacity to hold power and has to be
replaced.
When disconnecting charger, disconnect AC cord first, remove clip from vehicle chassis,
and then remove clip from battery terminal.