Protool VCP 450 E-L, Руководство пользователя

Страница: 14 / 92

Areas of employment and
operating methods
Hovering liquids
WARNING!
Exhaustion of dry materials
CAUTION!
Never use the device for hovering inflammable
liquids!
Before you start hovering any liquid, you must
remove the filtering / liquidating bag!
If foam appears in the course of operation, stop
the work immediately and empty the container
with dirt.
After the exhaustion of liquids the filter is wet.
Such filter gets clogged more quickly when
exhausting dry materials; therefore, it is
It is forbidden to exhaust inflammable
materials!
necessary to wash the filter and to dry it or to
replace it with a dry one before proceeding to
the dry exhaustion. Before exhaustion of dry
materials insert a filtration bag into the vessel.
In such a case, the exhausted material can be
liquidated simply and hygienically.
(Fig. 4)
Open the closing clasps.
Remove the upper part of the vacuum cleaner.
Tear a foil tape off the PE bag and tie up the bag
with it. Pull a cardboard flange off the opening
for the hose and close the flap. Full liquidation
bags must be treated in compliance with the
legal provisions related.
Attach a new liquidating bag according to the
instructions.
Push the cardboard flange over the opening for
the hose.
(Fig. 5)
Open the closing clamps. Remove the upper
part of the vacuum cleaner.
Pull the filtering bag cardboard flange off the
opening for the hose.
Close the filtering bag with a flap and liquidate it
in compliance with the legal provisions related.
Attach a new filtering bag according to the
instructions.
Push the filtering bag flange over the opening for
the hose.
(Fig. 14, 15, and 16)
Remove the upper part of the vacuum
cleaner out of the container with dirt and put
it aside, filter upward.
Open a tension clamp (A) of the tension
fixing and remove the tension fixing. ·
Remove the filter-tensioning wheel (B).
Remove the filter carefully.
Clean the filter seal (C) from the upper part
of the vacuum cleaner and the filter-
tensioning wheel, check for integrity and
damage, replace either of them if necessary.
Check for easiness of the controlling valve
operation (D) in order to clean the filter.
Attach a new filter and the filter-tensioning
wheel. The filter sealing tabs must be tight to
the filter seal (C).
Attach the tension fixing and close with the
tension clamp.
The used filter must be liquidated in
compliance with the legal provisions related.
Liquidating bag replacement
Filtering bag replacement
Filter replacement
o
o
o
o
o
o
o
o
WARNING!
Never start working without a filter!
Switching on the vacuum cleaner with
electric tools
Suction power regulation
Filter cleaning
Connect the electric tools to the instrument
socket (8) on the control panel.
Before bringing the switch to the position AUTO
make sure that the electric tools are
disconnected.
Bring the switch to the position AUTO. The
suction motor starts running once the electric
tools are switched on.
Once the electric tools have been switched off,
the vacuum cleaner still runs out for a little while,
in order to transfer all the dust from the hose into
the filtration bag.
By turning the switch, you can adjust the suction
power (Fig. 13)
In the course of the operation, the filter is
automatically cleaned in certain intervals. If the
filter is extremely dirty, it is recommended to
clean the filter manually (Fig. 8):
Pull the suction hose off the tool or jet,
Switch the vacuum cleaner on
(MAN/maximum performance), see Fig. 10.
Close the suction hose with your hand for
approximately 10 seconds.
Attach the suction hose back to the tool or
jet and continue working or switch the
device off.
o
o
o
o
14