Protool RGP 150-16 E, Оригинальная инструкция / Список запасных частей

Страница: 23 / 166

23
Changing grinding discs
Reduced material removal quality is caused
by tool wear. Grinding heads can be reused
after changing the grinding disc.
Place the removed cutter head [5-3] on a
clean and fl at base. Release screws [5-1]
and remove them. Clean clamping surfaces
of grinding head.
Replace grinding disc [5-2] with a new one
and secure again with screws [5-1]. Tighten
to a tightening torque of 5 Nm.
Changing lower brush
If the lower brush [6-3] is excessively worn,
its protective function will be impaired. It
therefore has to be changed.
Remove screws [6-1] and take off slide
plates [6-2]. Remove lower brush [6-3] in-
cluding springs [6-4]. Fit springs [6-4] on
bolts [6-5] of new lower brush and insert
brush. When doing this, ensure that the
springs fall onto the suction hood bolt [6-6].
Place slide plates [6-2] in position and se-
cure with screws [6-1]. Check mechanism
for correct function.
Changing front brush
If the front brush [7-1] is excessively worn,
its protective function will be impaired. It
therefore has to be changed.
Release screws [7-2] and guard panel [7-3].
Replace front brush [7-1] with a new one,
place panel in position and secure with
screws [7-2].
7.7 Dust extraction
Dust created during work can be harmful
to health, combustible or explosive.
The machine must be connected to a suit-
able extraction system (vacuum cleaner).
The vacuum cleaner must be suitable for
the processed material. If the vacuumed
dust is particularly harmful to health, car-
cinogenic or dry, a special vacuum cleaner
from the PROTOOL range must be used.
The extraction connector [1-1] is suitable
for an extraction hose with dia. 35 mm.
To guarantee optimum extraction and a
long service life of the cutting and grind-
ing tools, the extraction channels must be
cleaned regularly.
7.8 Balancer
The grinding is provided with a lifting eye
[1-10] for using a balancer.
This weight relief makes work easier, e.g.
on facades and walls.
7.9 Surface guidance system
BG-RGP 150
The surface guidance system allows the
machine to be guided in upright position
on the fl oor. The integrated weight guaran-
tees optimum contact pressure. The rollers
facilitate transport of the complete device
between the different places of use.
8 Work instructions
With the machine switched on, place it on
the surface of the workpiece and move it
in longitudinal and transverse direction in
a parallel or circular motion.
The material removal capacity is determined,
above all, by a suitably selected tool and
the setting of the material removal depth.
An excessive increase in pressure does not
results in increase material removal, but
rather leads to increased wear of the ma-
chine and grinding tools.
During the work process, ensure that the
extractor hose is not kinked or damaged.
Faulty extraction leads to increased dust con-
tamination and wear of the grinding tool.
CAUTION
During work, check whether the grind-
ing wheels continuously turn freely
about their axes. If they do not, re-
move them from the tool head.
9 Maintenance
- Wrapped electric tools can be stored in a
dry place without heating, with tempera-
tures not lower than –5 °C. Unwrapped
electric tools can only be stored in dry
places with temperatures not lower than
+5 °C, without sudden changes in the
temperature.
- The vent openings in the motor cover [1-6]
must not be obstructed; we therefore
recommend that you clean them regu-
larly, e.g. with compressed air.