Protocol Kaptur, Инструкция по эксплуатации

Страница: 11 / 23

TAKE–OFF:
1. Press the take off button. The remote will beep and the drone will hover a
few feet off the ground. Then gently advance the throttle to a desired height
and release. The drone will hover at that height.*
OR
2. From Idle mode, gently advance the throttle up to a desired
height and release. The drone will hover at that height.*
LANDING:
1. Press the landing button to lower
the drone to the ground.
OR
2. Push down on the throttle until
the drone is on the ground.
NOTE:
- The engine will shut off if you choose to hold the throttle down for 3 seconds.
- Emergency Shut Off: When in flight,
pull the throttle and direction stick to
the center at the same time and the
drone will shut off. Emergency Shut
Off only works at altitudes under 10 feet.
* The drone may drift a bit, especially in the first
30 seconds until the altitude sensor gets a good fix on the position.
Some drift is normal.
OPERATION: FLYING THE DRONE
STARTING THE ENGINE:
After synchronizing the drone, move the throttle up and release to go into Idle
mode. The blades will rotate but the drone will not lift.
OR
After synchronizing the drone, pull the throttle and direction stick to the center at
the same time and release. The blades will rotate but the drone will not lift.
UP
DOWN
7
*The lights on the drone may flash occasionally while the optical position sensor
automatically locks into place. Once it is locked, the lights will remain steady while
it has over 20% battery power.