Protocol dronium III AP, Инструкция по эксплуатации

Страница: 10 / 15

TRIM ADJUSTMENT
SIDEWAYS TRIM
When the drone drifts to the left or right side unintentionally, you can
correct it by pressing the trim button in the opposite direction until it
evens out.
FORWARD/BACKWARD TRIM
When the drone drifts forward/backward unintentionally, you can correct
it by pressing the trim button in the opposite direction until it evens out.
*NOTE: Trim adjustments are designed to counter drifts not caused
by wind.
Backward
Forward
TROUBLESHOOTING
POSSIBLE CAUSE SYMPTOM POTENTIAL SOLUTION
Dronium III
AP does not
respond
1. Communication between
controller and aircraft was
not synchronized during
set up
2. Battery power depleted
on aircraft, controller or
both.
1. To synchronize, turn on aircraft
first, place it on level ground, and
then turn on controller.
2. Charge aircraft and/or replace
batteries in controller.
Response to
control inputs
intermittent or
erratic
1. Controller battery power
nearly depleted.
1. Replace batteries in controller.
Dronium III
AP will not
hover or
strafe
correctly
1. The aircraft was not
on level ground during
synchronization.
2. Trim settings are incorrect.
1. Re-synchronize aircraft
and controller.
2. Recalibrate the Altitude Sensor.
3. Reset the trim buttons on
the controller and re-trim flight
controls.
*Allow 15 minutes to pass between full flights as this will give the motors a
chance to cool down. Failure to do so could wear out and shorten the life
of the motors.
14
15