Protocol AEROFLUX AP, Инструкция по эксплуатации

Страница: 9 / 11

TROUBLESHOOTING
POSSIBLE CAUSE SYMPTOM POTENTIAL SOLUTION
AeroFlux
AP does not
respond
1. Communication between
controller and aircraft was
not synchronized during
set up
2. Battery power depleted
on aircraft, controller or
both.
1. To synchronize, turn on aircraft
first, place it on level ground, and
then turn on controller.
2. Charge aircraft and/or replace
batteries in controller.
Response to
control inputs
intermittent or
erratic
1. Controller battery power
nearly depleted.
1. Replace batteries in controller.
AeroFlux AP
will not hover
or strafe
correctly
1. The aircraft was not
on level ground during
synchronization.
2. Trim settings are incorrect.
1. Re-synchronize aircraft and
controller.
2. Reset the trim buttons on
the controller and re-trim flight
controls.
*Allow 15 minutes to pass between full flights as this will give the motors a
chance to cool down. Failure to do so could wear out and shorten the life
of the motors.
FLYING OUTDOORS
HOW TO PREVENT FLY AWAYS
To prevent “fly-away” situations (where drones seem to fly away out of
control) it is important to first test and practice within close range before
letting the drone fly too far away.
Each drone is designed to land if the radio signal is lost. (But, this should
not be considered a landing procedure or normal flight practice.) It is
important to know and test the range of your drone before flying. We
recommend turning on and syncing the drone and walking away while
testing the engines. Keep walking and testing until it is obvious when
you reach the point where the signal is not controlling the drone. This will
be the control limit for the conditions in which you are flying. Distance
does vary somewhat based on environmental and weather conditions,
so testing the limit is advised. Fly in a range that is good for easy visual
operation of the drone.
IF YOU CAN’T SEE YOUR DRONE, THEN YOU CAN’T CONTROL
YOUR DRONE.
Fly-aways are not covered by warranty as they are overwhelmingly
caused by pilot error.
12
13
* RE-CALIBRATING THE DRONE
If the drone does not fly correctly even after adjusting the trim, you can
re-calibrate. Push the throttle to the lower left corner and direction lever to
the lower right corner and hold for 3 seconds. The lights will flash and then
go steady once calibrated.