The SLG™ BOLT is the main component of the SLG™ marker. In order to
achieve the best possible performance, it is essential that the SLG™ BOLT
is kept clean, well lubed and in good working order.
The SLG™ BOLT should be cleaned and re-lubed every 10,000 shots or
after breaking paint or playing in severe conditions.
The SLG™ bolt kit is composed of a 2 piece bolt, plunger, and back cap.
To remove the bolt kit, unscrew the back cap using a
1
⁄
4
” allen key. Insert the allen key into the back cap,
while depressing the bleed button. If there is any air
remaining in the SLG™, it will be purged when the bleed
button is depressed. If air continues to leak from the
bleed system, your air system is still feeding air into the
SLG™.
De-activate the air system and continue with the bolt
maintenance. Once you have unscrewed the back cap
and removed it from the body, the bolt should slide out.
For regular maintenance there is no reason to
disassemble the bolt kit any further.
FORWARD POSITION
BOLT
(DO NOT DISASSEMBLE FOR
REGULAR MAINTENANCE)
SILENCER
BLEED BUTTON
SLG™ BOLT
ASSEMBLY
SLG™ BOLT
OPERATION
BOLT BACK
SOFT
RUBBER
CUSHION
BACK CAP
BOLT TIP
PLUNGER
RING
HOW IT WORKS
At rest, when the bolt is in the rear
position, there is a positive forward
force on the bolt from the air pressure
in the shot chamber. The bolt is held
in the rear position by the sear. When
the SLG™ is fired, the sear is dropped
by an electro-magnetic solenoid.
The positive forward force drives the
bolt forward until the bolt drops off
the plunger and allows the shot
chamber air to vent down the bolt and
fire the paintball. Once the shot
chamber has been fully vented, the air
supplied to the bolt creates a positive
rearward force that drives the bolt
back and allows it to catch on the sear
again. As the bolt travels rearward,
the shot chamber is filled and the
cycle is repeated.
When servicing your marker:
• Make sure your hopper is removed from the marker.
• Make sure there are no paintballs in the breech of the marker.
• Always remove the air supply and relieve all gas pressure in the marker
before disassembly.
• When using the marker in temperatures below 50° Fahrenheit it may be
necessary to lube the SLG™ bolt more frequently.
BACK POSITION
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
13
12
