TROUBLE SHOOTING GUIDE
TROUBLE SHOOTING GUIDE
• Check that the solenoid cable is attached to
the blue female connector on the board.
TRIGGER BOUNCE / SLG™ SHOOTING MORE
THAN ONE BALL PER PULL IN SEMI AUTOMATIC
MODE
• Raise the trigger sensitivity level in the
configuration mode.
• Check that the trigger is not adjusted too short.
• Make sure there is a trigger spring inside the
frame.
• Be sure the bolt is screwed together snugly.
ERRATIC VELOCITY / SLG™ WON’T FIRE
SLG™ FIRES BUT BALLS ARE DROPPING OFF OR
NOT EVEN COMING OUT OF THE BARREL
• Make sure the battery is good.
• Make sure bolt is clean, well lubed, and moves
well. If there is too much friction in the bolt it
will cause the SLG™ to shoot down.
• Make sure air system is screwed in all the way.
• Make sure airport screw is adjusted correctly.
• Make sure the front bumper O-ring is not
blocking the inlet hole located on the back
of the bolt.
SLG™ WILL NOT FIRE BUT SOLENOID CLICKS
• Press the bleed button on the back of the bolt
several times, listen for bolt moving rearwards.
If the bolt is still not moving, de-pressure the
SLG™ and remove back and bolt, add lube to
the bolt and reassemble.
BREAKING PAINT
• Make sure you use high quality paintballs and
that they are stored according to the
manufacturers instructions.
• Check that #14 O-ring on bolt tip is in place
and in good condition.
• Make sure your loader is working and that the
rate of fire is not set higher than the maximum
feed rate of the loader.
• Check that the barrel you are using is not too
tight for the paintballs you are using.
• Eyes are clean/on.
NOTES:
FIRST SHOT IS TOO HIGH
• Change the Seat inside the Hyper3™ regulator.
For disassembly instructions consult the
technical section on page 21.
VELOCITY IS NOT CONSISTENT
• Make sure the paintballs you are using fit the
barrel good and are consistent in size.
The stock barrel with the SLG™ is .690 size.
You should be able to blow the paintball
through the barrel but they should not roll
through the barrel on their own.
• Remove the bolt kit and re-lube it. Change any
O-rings causing a lot of friction. Make sure
#014 O-ring in bolt tip is in place and in good
condition.
• Change the battery.
• Check that the Hyper3™ regulator is working
good and that the pressure is consistent.
A separate regulator testing tool is available for
this. If needed, disassemble and change worn
out O-rings in the Hyper3™ regulator.
OTHER CATEGORIES
DOUBLE FEEDING
• If you get two balls firing at once check to see
that the Ball Detents are not stuck down.
• Make sure the Ball Detents are not excessively
worn.
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
26
27
