Protege Pumps PS16 Скачать руководство пользователя

Страница: 10 / 13

Pool / Spa Pump

E&OE

Operation

•

Once the plumbing and pump have been installed and the pump is

primed

, switch the pump ON at the

mains electrical supply.

•

It is recommended to use an electrical timer to automate switching the pump ON and OFF during the day

/ night.

Maintenance and Troubleshooting

Disconnect the pump from the electrical supply before performing any maintenance. • The

pump should be cool enough to touch before performing maintenance activities. • Stop any

water flow to the pump from the pool on both inlet and outlet side before performing any maintenance

activities. • Some maintenance activities described may be beyond the scope of some users. For procedures

that you are not comfortable with or have the knowledge, tools or experience for, have the unit serviced by a

service centre or qualified technician.

•

The pump strainer basket should be inspected and cleaned at regular intervals. Remove the pump lid

(rotate left), then remove the basket and clean it. Re-install the strainer basket. Ensure that the lid and

any seals are totally clean and free of any particles, then re-install the lid and firmly tighten (rotate right)

by hand. It is recommended to lubricate any seals with suitable lubricant.

•

If your pool is deactivated for an extended period, stop any water flow to the pump from the pool on both

inlet and outlet side, then remove the drain plug at the bottom of the pump to drain it. Do not replace the

drain plug, but store it in the strainer basket until the pump is required again. An alternative is to remove

the pump and store it indoors in a dry location. If the pump is used with salt water, it is necessary to flush

it with clean water. It is also recommended that the seals be replaced before next use.

Troubleshooting

Symptoms

Probable Causes

Recommended Actions

Pump will not prime.

Air leak in inlet side.



Ensure the pool water level is high enough.



Ensure that the pump lid and drain plug are installed

correctly and not leaking.



Ensure that all plumbing and connections are air-tight.



Replace the pump seal.

No water in the pump.



Make sure that the pump tank is filled with water.

Closed valves or blocked

lines.



Ensure all valves in the system are fully open.



Clean the skimmer and pump strainer baskets.



Check the pump for any obstructions.

Pump motor not

running.

No electrical power.



Ensure that the electrical supply is within specification,

switched ON, and that power is reaching the pump.



Ensure that the fuse or circuit breaker is properly set.



Ensure that any timer is properly set and operating

correctly.



Check the motor wiring at the terminals.

Pump is jammed.



Check pump and remove any obstructions to the impellor.

PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS PROTEGE PUMPS