Protec TC-512A, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 26

24-26
Tire press roller can’t touch dismounting head or steel rim.
Watch if it can touch other parts of the machine during work. Otherwise haltthe
machine.
Auxiliary facility can’t replace.
7. Storage
In the event of storage for long periods of time, be sure to disconnect all sources of
power
Keep in good ventilation, dry place, and movable parts should be fixed.
Grease the clamp sliding guides on the turntable to prevent from oxidizing.
8. Scrapping
If you decide scrape the machine, be sure to make it inoperative bydisconnecting it
from all sources of power.
Remove all non-ferrous materials and dispose of them as prescribed bynational law.
Collect the oil and dispose of it at an authorized point as prescribed bynational law.
Scrape the rest ferrous material.
9. Maintenance
Tighten the fixing screws timely.
Dust-cleaning need be done to guiding bed and gliding block timely.
Apply lubricant in guiding bed, gliding block and the shaft of air cylinder.
10. General questions and resolve
1). Insufficient pressure during work
Adjust the pressure of air
source to required pressure, check if there’re any parts of
leaking, and replace the defect parts.
2). Working parts don’t run smoothly
Adjust screws on gliding block; ensure the distance not too big between guiding bed
and slide.