ProTeam AC10P, Инструкция по установке и эксплуатации

Страница: 12 / 36

12
A) Inspection of the heat pump
- Check whether the outer appearance of the unit or piping system has been
damaged during transportation.
- Check that the ventilator fan does not touch any part of the unit.
B) Verifying the electrical connections
- Check that the power supply complies with the specifications in this manual or
on the label placed on the unit.
- Check whether the power cabling is connected correctly and firmly according to
the wiring diagram. Adequate grounding is required to protect against electrical
shock.
3.1 Controller diagram
A. : Switch heat pump on or off
B. MODE: Select auto, heating or cooling mode.
Corresponding indicator light will go on when selected
C. ▲ or ▼ : Press to change digits.
D. : ‘Timer start’ setting button
E. : ‘Timer stop’ setting button
F. : Time setting button
3.2 How to start heat pump
When connected with power, the controller will display the time. This means that the unit is in
standby. Press to start the heat pump. The controller display will now show the inlet water
temperature.
Please note : If the buttons are touched many times, the processor will stop working
and you will be not able to change the mode. In this case turn off and then on the power
to the heat pump.
3.3 How to change mode
Press MODE to select auto, heating or cooling mode: the indicator light on the right side of the
controller will indicate the mode selected.